Microfluidics
PyroScience offers special oxygen nanoprobes for applications in microfluidics. These nanoparticles incorporate our REDFLASH indicator which responds to the oxygen partial pressure inside the chip.
Additionally, it is possible to use sensor spots for oxygen, pH and temperature measurements and integrate this sensor spots into the microfluidic chip.
With our PICO2 read-out device it is possible to measure oxygen of even tiny sensor spots inside a chip.
Common applications with our sensors are:
- Oxygen measurements with real-time response in microfluidic chips
- Chemical/enzymatic reactions
- High-throughput screening
- Lab-on-a-chip applications
Applicable Sensor Types
Related Peer-Reviewed Publications
Efficient gas–liquid contact using microfluidic membrane devices with staggered herringbone mixers
Femmer et al., 2015, Lab on a Chip
https://doi.org/10.1039/C5LC00428D
Drag Reduction by Bubble-Covered Surfaces Found in PDMS Microchannel through Depressurization
Gao et al., 2016, Langmuir
http://doi.org/10.1021/acs.langmuir.6b01186
Microfluidic system for Caenorhabditis elegans culture and oxygen consumption rate measurements
Krenger et al., 2020, Lab on a Chip
http://doi.org/10.1039/c9lc00829b
Downscaling screening cultures in a multifunctional bioreactor array‐on‐a‐chip for speeding up optimization of yeast‐based lactic acid bioproduction
Totaro et al. 2020, Biotechnology and Bioengineering
https://doi.org/10.1002/bit.27338